King Kutter 999995 User Manual

Page 8

Advertising
background image

8

XB-ROTARY TILLER ASSEMBLY INSTRUCTIONS

STEP 1

With rotary tiller still in crate, lay flat on a level surface. Cut banding straps on the two (2) upright crate
posts.

STEP 2

Remove the top & upper side sections of the crate, leaving the rotary tiller resting on the bottom sec-
tion.

STEP 3

Remove tie wire holding the PTO shaft and set aside PTO.

STEP 4

Attach tiller according to your tractors manual and using the instructions on pages 16 and 17.

STEP 5

Install tail back plate chain.

STEP 6

Install PTO shaft as outlined in the Attaching to Tractor Section, pg 16-19.

Note: The safety chains on the PTO shaft should be attached to the tractor
and tiller to prevent the plastic safety shield from rotating.

BEFORE PUTTING ROTARY TILLER INTO SERVICE

(IMPORTANT-INSTRUCTIONS PRIOR TO START UP)

SHIPPED WITHOUT OIL IN GEAR BOXES AND WITHOUT GREASE IN
GREASE FITTINGS. UNIT MUST BE SERVICED BEFORE USING.

Fill Gearbox using gear oil (type SAE-EP-80W 90.)

For all Grease Fittings use TYPE/grade II tube grease.

STEP 1

Place rotary tiller so that the deck is secure and level.

STEP 2

Remove Oil Plug (Located at top of transmission gearbox). See Figure A
& B.

STEP 3

Fill gearbox using gear oil until gearbox is approximately 1/2 full (16 oz).
The plug has marks on it. (See FIgure C) Make sure oil level is close to top
line, but not over it. DO NOT OVERFILL!

Advertising