King Kutter 999995 User Manual

Page 9

Advertising
background image

9

STEP 4

Replace and tighten the oil plug and clean away any excess oil.

STEP 5

Remove Oil Plug (Located at top of side gearbox, See (FIG. D point A),
there is a sight glass (Located in the side of the side gearbox) (FIG. D
point B & Close-up Figure E) fill oil until oil is to top of glass.(20 oz.)

STEP 6

Replace and tighten the plug. Clean away any excess oil.

STEP 7

Grease the grease fitting on the "outboard hub," the two (2) grease fittings on
the PTO universal joints, the two (2) grease fittings on the PTO safety shield
and the inner surface portion of the PTO shaft. See Figures F, G and H.

CAUTION:

DO NOT over fill gearbox. This could cause damage to oil seals and can
cause permanent damage to the gearbox. This issue will not be covered
under warranty.

Figure A

Figure B

Figure C

Advertising