Kenwood MD-MT877W - Manual (Page 54)

54
References
–
Error Messages
–
Error Messages
ERROR MESSAGES
BATT EMPTY
(LoBATT)
BLANK MD
(BLANK)
Can’t COPY
(Can’tC)
Can’t EDIT
(Can’tE)
Can’t READ *
(Can’tS)
(Can’tT)
(Can’tU)
Can’t REC
(Can’tR)
Can’t STAMP
Can’t WRITE
(Can’tW)
CHARGEmode
DEFECT
(DEFECT)
DISC FULL
Er-MD **
(ErMD*)
HOLD
(HOLD)
LOCKED
(Can’tLOCK)
MEANING
● The battery is run down.
● Nothing is recorded.
● You tried to record from a copy prohibited
MiniDisc.
● A track cannot be edited.
● The disc data cannot be read because the disc
is damaged.
● Recording cannot be performed correctly due to
vibration or shock.
● Stamp function does not work.
● Cannot save the TOC information correctly to a
MiniDisc. (A large portion of the disc has been
damaged.)
● The Charge/Operation switch is not set to the
operation mode when using this unit with the AC
adaptor.
● The disc is scratched.
● The disc is out of recording space.
● The microprocessor has reported a system fault
and the unit is out of order.
● The unit is in the hold mode.
● You removed a MiniDisc whilst recording or
editing.
REMEDY
● Charge the rechargeable battery or replace the alka-
line battery (or use the AC adaptor for power).
● Replace the disc with a recorded disc.
● Record using the analogue cable.
● Change the stop position of the track and then edit it.
● Reload the disc.
● Replace it with another recorded disc.
● Re-record or replace it with another recordable disc.
● Check the number of tracks.
● Replace the disc with another recordable disc.
● Set the Charge/Operation switch to the operation mode.
● If the sound you hear is not right, record again.
● Replace the disc with another recordable disc.
● Replace it with another recordable disc.
● To have it repaired, go to the distributor where you pur-
chased the unit.
● Return the HOLD switch to its original position.
● Turn off the power and remove the MiniDisc.