Kenwood MD-MT877W - Manual (Page 55)

55
References
–
Error Messages
–
Error Messages (continued)
ERROR MESSAGES
NO DISC
NO SIGNAL
(noSIG.)
PLAY MD
(PLAYmd)
POWER ?
PROTECTED
SORRY
(Sorry)
TEMP OVER
(TEMP!)
TOC FORM **
(Tform**)
TOC FULL
Tr. Protect
? DISC
(? DISC)
MEANING
● A disc has not been loaded.
● Poor connection of the digital cable.
● No output signal comes out from the connected
unit to playback.
● The input signal has improper sampling fre-
quency.
● You recorded on a playback-only disc.
● The battery charger is defective.
● The write protection tab of a MiniDisc is set to
the protected position.
● You tried to record on a playback-only disc.
● Since a track number is currently being located
or updated, the unit cannot accept your com-
mand.
● The temperature is too high.
● There is an error in the recording signal.
● There is no space left for recording character
information (track names, disc names, etc.).
● The track has been protected from being erased.
● A disc which contains data other than music was
played.
● There is an error in the signal recorded on the
disc.
● Stamping is not possible.
REMEDY
● Load a disc.
● Connect the digital cable securely.
● If the portable CD player has a function to prevent sound
skips, deactivate it.
● Playback with the connected unit.
● Replace it with a recordable disc.
● To have it repaired, go to the distributor where you
purchased the unit.
● Move the write protection tab back to its original position.
● Replace it with a recordable MiniDisc.
● Wait for a while and try the operation again.
● Turn off the power, and wait for a while.
● Erase all of the tracks, and then record again.
● Replace it with another recordable disc.
● Edit the track with the device on which it was recorded.
● A disc which contains non-music data cannot be played.
● Replace it with another recorded disc.
● Retry.
( ) : Error messages seen on the remote control.
Number or symbol appears in * position.