Kenwood TK-7160 - Manual (Page 16)

10
BASIC OPERATIONS
S
WITCHING
P
OWER
ON/ OFF
Press the switch to switch the transceiver ON.
• A beep sounds. If programmed, an 8-character power-on message is also
momentarily displayed.
• If the Transceiver Password function is programmed, “ ” will appear on the
display when the power is turned ON. Refer to “Transceiver Password”, below.
Press the switch again to switch the transceiver OFF.
■ Transceiver Password
To enter the password:
1 Press the and keys to select a digit.
2 Press the C> key to accept the entered digit and move to the next digit.
• Press the A key to delete an incorrect character. Press and hold the A key to
delete all entered characters.
• Repeat steps 1 and 2 to enter the entire password.
3 Press the S key to confirm the password.
• If you enter an incorrect password, an error tone sounds and the transceiver
remains locked.
To enter the password using an optional DTMF keypad:
1 Press the DTMF keys corresponding to the password digits.
• Press the A or DTMF # key to delete an incorrect character. Press and hold the
A or DTMF # key to delete all entered characters.
2 Press the S or DTMF key to confirm the password.
• If you enter an incorrect password, an error tone sounds and the transceiver
remains locked.
A
DJUSTING THE
V
OLUME
Press the Volume Up ( ) key to increase the volume. Press the Volume Down
(
) key to decrease the volume.
If Squelch Off has been programmed onto a key, you can press and hold the
Squelch Off key to listen to background noise while adjusting the volume level.