Knoll Systems HDP404 - Manual (Page 11)

11
When the lamp comes on, the start-up screen is displayed
and the LED is steady green. It can take a minute for the
image to achieve full brightness.
? No start up screen? Get help on page 13
Plug in, connect, and turn on your video device.
The video device’s image should appear on the
turn on video device
projection screen. If it doesn’t, press the Source button
on the remote until the image appears.
? No image? Try pressing the Auto Image button on the remote. Get help on
page 13.
Adjusting the image
Adjust the height of the image by tilting the projector adjust height
up or down.
Position the projector the desired distance from the screen at a 90-degree angle to the screen.
See page 8 for a table listing screen sizes and distances to the screen.
Adjust the zoom and focus.
If the image is not square, adjust the keystone
adjust
using the Picture menu. See page 17 for details. keystone
Adjust the volume on your stereo receiver.
adjust volume
Your projector has been factory optimized for adjust Picture menu options
excellent performance no matter what the source. including Aspect Ratio
However, if you wish to make further changes you
can optimize the image using on screen menus.
Adjust the Contrast, Brightness, Color, Tint, or Aspect Ratio
in the Picture menu. See page17 for help with the menus and these
adjustments.
For Aspect Ratio, keep in mind that DVD players must be configured for 16:9 in order to view the
highest quality image. For more information regarding Aspect Ratio, see page 8.
Shutting down the projector
Power Save
The projector also has a Power Save feature that automatically turns the lamp off after no active
sources are detected and no user interaction with the projector is performed for 20 minutes. By
default, this feature is on. See page 21.