Knoll Systems HDP404 - Manual (Page 19)

19
Gamma: Gamma tables contain preset intensity
configurations optimized for the input source.
You can select a gamma table that has been
Gamma
specifically tuned for either film, CRT
(Cathode Ray Tube), Video, PC, or Bright
Room input. (Film input is material originally
captured on a film camera, like a movie; video
input is material originally captured on a video
camera, like a TV show or sporting event.)
White Peaking increases the brightness of whites that are near 100 percent.
NOTE: Your viewing preferences may vary. Cycle through the gamma options and pick the one
you like the best.
Overscan: Removes noise from around the edges of the video image.
Select zoom to remove the outer 3% of the image and scale the image
back to its original size. Select crop to remove the outer 3% of the
image without rescaling.
Advanced menu
Advanced menu
Remember that not all options in the menus are
available for all sources/ signals.
Iris: Iris adjusts the aperture of the Iris from 0 to 100
(fully open) to regulate the amount of light emitting from
the projector. Close the aperture to increase the contrast
in dark images.
Phase: adjusts the horizontal phase of a computer
source.
Tracking: adjusts the vertical scan of a computer
source.
Horizontal/Vertical Position: adjusts the position of a
computer source.
Sync Threshold Adjust: (progressive signals only).
If a hardware device, such as a DVD player, is not
syncing properly with the projector, adjust this
option to help it to sync when connected to the projector.
Flesh Tone Correction: this modifies colors to make
the skin complexion better. Sharpness
Film Mode: controls de-interlacing and is On by default.
When checked, it assumes the incoming signal is film
material and optimizes the image accordingly.
Sharpness: (video sources only) changes the clarity
of the edges of a video image. Select a sharpness setting.