Knoll Systems HDP404 - Manual (Page 6)

6
• HDMI™ (High Definition Multimedia Interface)
• Component (RCA)
• SCART RGB (you must enable this connector, see page 9)
• S-video
• Composite video (RCA)
See “Video connectors” on page 9
for details.
The projector also provides the following connectors:
• RS-232 for serial control (not included on the HD108)
• 12-volt DC output (see below)
12-volt DC output
The 3.5mm mini-jack trigger provides a 12-volt, 0.25 amp DC output. It provides a constant output
while the projector is on. It has numerous uses. For example, if you connect your projection
screen to the 12-volt DC output with the cable that came with your screen, when you turn on the
projector the screen will move down; when you turn the projector off, the screen will return to the
storage position.
12V+
ground
3.5mm plug 12VDC output
screen relay (see
screen manufacturer for details)
Setting up the Projector
There are a number of factors to consider when determining where to set up the projector,
including the size and shape of your screen, the location of your power outlets, and the distance
between the projector and the rest of your equipment. But here are some general guidelines.
NOTE: To ensure adequate cable access, do not place the
projector within 6 inches (0.15 m) of a wall or other object.
Position the projector on a flat surface (either on a table or ceiling mounted) at a right angle to the
screen.
The projector should be within 10 feet (3 m) of your power source and within 6 feet (1.8 m) of
your video source(s), unless good quality extension cables or baluns are to be used.
When installing the projector on the ceiling, refer to the installation guide that comes with the
Ceiling Mount Kit for more information. Knoll recommends use of the mount shipped with the
projector or the deluxe swivel Knoll CM26 ceiling mount. The addition of a CM20+6 extension bar
lowers the projector 6” per bar as required. The CM25EX is an adjustable extender that can lower
the projector 6.75” to 11” (17-28 cm). The ceiling mount kit may be sold separately.