Kathrein UFS 733si - Manual (Page 15)

15
FIRST INSTALLATION: Single-cable system (general)
Use the

buttons here to select “One Cable” as “LNB control”. Press the

button to move to the
next menu item:
Satellite selection
Press the button. The following display appears:
The various options
for a single-cable
system with Kathrein
components are
summarised at
the end of this manual in
the “Technical Appendix”
section under “Examples of
Single-Cable Systems”.
Depending on the system to which
they are connected, a maximum
of four or eight receivers may
be connected to a single-cable
system (a twin receiver counts
as two receivers).
Use the

buttons here to select the satellites you want to receive with your system. Press
the
!
(green) button to open the next menu:
Note: You can only receive the signals from two satellites in your single-cable system if a
EXU 908 single cable matrix is used. In this case, repeat the “Satellite selection” process for
the “Position B” line.
If the receiver is
connected to a
UAS 481 single-cable
LNB, it is imperative
the two frequencies
(low band/high band) are set to
10200 MHz here.
You can make the settings using
either the number pad or the

buttons.