Kyocera Lingo M1000 - Manual (Page 9)

User Guide 1
1 G
ETTING STARTED
Phone battery
Installing the battery
To install the battery:
1.
Hold the phone
face down and locate
the screw on the
back cover.
2. Turn the screw to set
the screw slot in
vertical position to
unlock the back cover.
3. Locate the groove on
the left side of the
phone and unsnap the
hooks to remove the
back cover.
4. Place the battery in the
phone casing with the
metal contacts of the
battery touching those
of the phone.
5. Replace the back
cover by sliding the
notches into the
opening on the
left side.
6. Snap the back panel
into place.
7. Set the screw slot in
horizontal position to
lock the back cover.
Note: To remove the battery,
make sure the phone is
powered off.
Charging the battery
You must have at least a partial charge in the
battery to make or receive calls.
To charge the battery:
1.
Connect the AC adapter
to the jack on the bottom
of the phone. Do not
force the AC adapter into
the jack.
2. Plug the adapter into a
wall outlet.
The battery icon in the upper-right corner of the
screen tells you whether the phone is:
• Charging (animated icon)
• Partially charged
• Fully charged
Warning: The battery does not charge if you use
the phone while it is connected to an AC adapter.
Recharging the battery
You can safely recharge the battery at any time,
even if it has a partial charge.
82-G1934-1EN.book Page 1 Sunday, October 14, 2007 6:19 PM