KTI Networks Modular Media Converter Center System KC-1300 - Manual (Page 30)

-30-
Direct Console Management
When you can see the self-test messages shown on screen properly, you
can press <Enter> key to start console login operation. Go to Login
Prompt section in next page directly.
Telnet Management
Use Telnet software to perform the management operation. The most
convenient solution is using the built-in Telnet function in a Windows
95/98/ or NT PC. Enter into DOS window and invoke Telnet command :
>telnet xxx.xxx.xxx.xxx
to connect to the system unit. The specified xxx.xxx.xxx.xxx is the IP ad-
dress of the system unit. A welcome message and login prompt are dis-
played if the connection is established properly.
Login Prompt
The following figure illustrates the login screen:
---------------------------------------------
Welcome to Console
login:admin
password:***
---------------------------------------------
Username : admin
Factory default Password : 123
For security reason, the system supports a function to change the pass-
word in setup menu. It is recommended to change the default password
immediately after a successful login.