Station name preset (snps), Switching display for tuner – Kenwood KRC-609 User Manual

Page 11

Advertising
background image

You can change the display used when listening to the radio.

Changing the Display:

Each time you press the DISP button, the display changes as
follows:

Station frequency

SNPS name (only when being preset)

Switching Display for Tuner

Assigning Names
Press the NAME.S button.
The name of the station is stored in memory, and the Station
Name Preset mode ends.
Also, if you make no input for 10 seconds, the name will be
stored up to the point that you have entered, and the mode
ends.

• You can assign names to up to 32 FM stations and 16 AM

stations.

• All the station names will be erased if you press the Reset

button.

• If you want to change the name of a station, first display the

name of the station (following steps 1 and 2 above), then
change the letter(s) that you want by following steps 3 and 4.

NOTE

6

You can assign names to radio stations with the Station Preset
Memory. Up to 32 FM stations and 16 AM stations can be
assigned names.

Adjust the frequency to the station whose name you want to
enter.

Press the NAME.S button for at least two seconds.
"NAME SET" is displayed once the station name preset mode
is entered.
The cursor will blink in the position where letters are entered.

Press either the

4 or ¢ button to move the cursor to the

desired position.
The

4 button moves the cursor to the left, and the ¢

button to the right.

Each time the

38 button is pressed, the characters to be

entered change as listed below.
Press the FM or AM button to display the desired character.
Characters that can be displayed are as follows.

Continue steps 3 and 4 until all the characters are chosen for
the name.

You can enter up to eight characters for each name.

NOTE

5

Alphabet (upper case): A ~ Z

Alphabet (lower case): a ~ z

Numerals and symbols: 0~9 @ ” ‘ ` % & * + - = , . / \ < > [ ]

Special characters: б а й и н м у т ъ щ С З ® Я ‹ fl

в д к л о п ф ц ы ь с з © Ж › fi

4

3

2

1

Station Name Preset (SNPS)

Press the preset station button (#1-6) for the desired station.
The number of the recalled station is displayed.

— 11 —

KRC-609_U.S 00.12.26 3:29 PM Page 11

Advertising
This manual is related to the following products: