Key Digital KD-CDA3 - Manual (Page 16)

KD-CDA3 Operating Instructions
Page 27 of 29
KD-CDA3 Operating Instructions
Page 26 of 29
■ Weight: 1.5 lbs. (0.7 kg.)
■ Enclosure Type: Metal
■ Plastic mounting bracket, included
Mounting Information
■ A convenient mounting bracket is provided
■ The top and bottom of the unit are solid metal (no vents)
■ The unit may be oriented horizontally, or mounted vertically on a wall
➾ Use #8 or M4 screws to hang the unit (keyhole slots are provided on the base of
the unit)
CAUTION: If installing the KD-CDA3 unit or Mounting
Bracket into sheet-rock or hollow walls, provide proper
screw support with bolts or sheet-rock anchors.
Power Requirements
■ External power supply
■ + 5V DC, 110-120 VAC, 60 Hz (7 watts)
CAUTION: No other power supply adapter can be used with
this unit! Using a power supply other than the one provided
by Key Digital
® with your unit VOIDS THE ENTIRE PRODUCT
WARRANTY, may cause damage to your unit and associated
equipment, and is a potential safety hazard.
Cable Recommendations
■ Each run of YPbPr cable MUST be the same length (300’ maximum)
Bandwidth
■ -3 dB @ 300 MHz
■ Linear phase pass-band
■ Drives video signals up to 300 feet
Video Gain
■ Unity gain for YPbPr and RGBHV
Analog Audio
■ Analog stereo (Left and Right) Audio
■ Two RCA-type color-coded input connectors (L, R)
■ High-impedance (1K ohm) line level inputs
■ RGBHV installations preclude Audio distribution with your KD-CDA3 unit
Digital Audio
■ Use the analog Audio Left and Right connectors for digital PCM Audio
■ Standard PCM digital format
■ RGBHV installations preclude Audio distribution with your KD-CDA3 unit
Mechanical
■ Size: 4” x 8” x 1-13/16”
KDCDA3_OperInstructions.qxd 1/4/06 12:58 PM Page 26