Kathrein UFD 505 - Manual (Page 38)

Installation menu
The signal quality and the search progress
are indicated during the search.
The message appears at the end of the
search.
All new programmes are added to the
existing programme list.
The search is complete
Press (OK) button
You can interrupt the search by pressing the
L
button.
TP set-up/search
In this menu you can scan through the
transponders for specific programmes,
e.g. when new programmes are offered in
the package of a specific broadcaster. You
can obtain this information from SAT 1
teletext or corresponding TV and satellite
magazines as well as from the Internet.
Press
O
to open the menu.
Transponder selection
The following settings are now possible (select positions with
ou
):
- Required satellite with
-
or
+
, the
transponder frequency with numerical
buttons,
- the polarisation with
-
or
+
button,
- the symbol rate with the numerical
buttons and
- search mode for free-to-air or free and
encrypted programmes with the
-
or
+
button.
The bar diagram indicates the relative
signal strength and is not an indication
for the quality of the receiving system.
Start the search by pressing
O
in the
"search" position.
The shown on-screen display appears as the result of the search.
Exit this menu by pressing
O
and go to the previously highlighted programme
(here ZDF).
Press the
L
to return again to this menu to continue searching for further trans-
ponders.
38