Kathrein UFD 505 - Manual (Page 39)

Installation menu
After an unsuccessful search the following message appears:
All new programmes are added to the existing programme list.
Under the menu item „Delete TP“ you can remove the transponder from the pro-
gramme memory by pressing
O
. You will be requested to confirm that you wish
to remove the transponder before it is deleted.
DiSEqC (UFO) Set-up
You should only make changes in this menu when the receiver is to be connected
to another receiving system with different
features or if changes have been made to
the receiving system.
Therefore, take particular note of the information relating to your Sat-IF system. Be-
fore making any changes, you should make a note of these settings on the form
provided at the end of this User's Guide.
Press the menu buttons
M
,
ou
and
O
to open the DiSEqC menu.
Error
22-kHz signal
In this menu point you can determine whether the 22 kHz signal is to be used to
switch over between the low and high frequency range of a satellite or between 2
satellite positions.
Tone-burst and DiSEqC signal
A DiSEqC control signal is necessary if more than four control criteria are required
in a receiving system.
Which of the setting options, i.e. tone burst or DiSEqC, is required depends on the
components of the receiving system.
Therefore refer to the description of the components (switchover matrices) of the
receiving system.
39