Kenwood KRF-V7010 - Manual (Page 19)

19
Operations
KRF-V7010/V6010/V5010 (En/T)
Presetting radio stations manually
• Repeat steps 1, 2, 3 and 4 to store as many stations as
necessary.
• If you store a station at a previously used preset, the old station will
be replaced by the new one.
Press the MEMORY key while receiving the station.
Proceed to step 3 within 5 seconds.
(If more than 5 seconds elapse, press the MEMORY key again).
Blinks for 5 seconds Lights for 5 seconds
1
2
Tune to the station you want to store.
3
4
Receiving preset stations
Enter the number of the preset you want to receive (up to
"30").
1
2
Press the numeric keys in the following order:
For "15", press .......... 0 , 5
For "20", press .......... 0 , 0 , )
• If you make a mistake entering a two digit number, press the +10
key several times to return to the original display and start again.
Use the MULTI CONTROL to select one of the station
presets (1 – 30).
Press the MEMORY key to accept the setting.
Use the remote control to select the tuner as the source.
• The remote control switches to the tuner operating mode.
The RDS auto memory function assigns preset numbers to RDS
stations starting from preset number "1". Therefore, be sure to execute
the RDS auto memory function before using the following operations to
manually store AM stations and other FM stations, and RDS stations.
“Presetting RDS stations (RDS AUTO MEMORY)”.
*
MEMORY
MULTI CONTROL
01 8 )) 9. FM
MHz STEREO
A SP
TUNED
MEMO.
AUTO
ST.
SW
R L
• When storing radio stations manually, it may take a few seconds
before the " MEMORY " indicator appears in the display after press-
ing the MEMORY key depending on receiving conditions.
AUDIO
TUNER
1-0, +10
RC-R0507 RC-R0307
1-0, +10
15 8 )) 9. FM
MHz STEREO
A SP
TUNED
MEMO.
AUTO
ST.
SW
R L
Receiving preset stations in order
(P.CALL)
• Each time you press the key, another preset station is received in
order.
Pressing the P.CALL ( % ) key ( ¢ ) does the following:
01 = 02 = 03 = ...... 28 = 29 = 30 = 01 = 02 = 03 =
Pressing the P.CALL ( fi ) key ( 4 ) does the following:
01 + 02 + 03 + ...... 28 + 29 + 30 + 01 + 02 + 03 +
Holding down the key, lets you skip through the presets, receiv-
ing each for 0.5 seconds apiece.
1
2
Use the remote control to select the tuner as the source.
• The remote control switches to the tuner operating mode.
Use the P.CALL key to select the desired station.
Listening to radio broadcasts
AUDIO
TUNER
P.CALL
P.CALL
RC-R0507 RC-R0307