Kenwood KRF-V7010 - Manual (Page 26)

26
Other
KRF-V7010/V6010/V5010 (En/T)
Memory back up function
Please note that the following items will be deleted from the unit's
memory if the power cord is disconnected from the AC outlet or the
main power switch is turned off for approximately 3 days.
Remote control unit
Cause
• Batteries are exhausted.
• The remote control unit is too far away from the
main system, controlling angle is too large, or
there is an obstacle between the receiver and
the remote.
• The audio cords and system control cords are
not connected properly.
• No software is loaded in the source compo-
nent.
• An attempt is made to play a tape which is
being recorded in the cassette deck.
Remedy
• Replace with new batteries. @#
• Operate the remote control unit within the
controllable range.
• Connect properly referring to “Setting up the
system”. 8
• Place software in the source component you
want to play.
• Wait until recording has completed.
Symptom
Remote control operation is not possible.
• Power mode.
• Input selector settings.
• Volume level.
• Broadcast band.
• Frequency setting.
• Preset stations.
In case of difficulty