Kathrein DVB Cable Receiver UFC 662sw - Manual (Page 44)

44
SEARCH CHANNELS (CHANNEL SEARCH)
After completion of the search,
you will see the following message
(example):
Press the

button. You will be asked whether you wish to save the changes or not. Selection
is performed using the

buttons and is confi rmed by pressing the

button. If you
select “Yes, save changes”, the newly found channels will be added to the end of the channel
list. Then press the button to exit the menu. The channel list is called up on to the TV screen by
pressing the

button (see also section “On-Screen Displays” “Channel List TV/Radio”).
Channel Search Mode
Use the

buttons to select whether you wish to search “free and scrambled” or “only free”
channels.
Network Search
Use the

buttons (On/Off) to select whether a network search should be performed. If you set
this to “On”, the networking of the transmission channels enables additional transmission channels
that have not yet been saved to be located. They are then saved and searched for new channels
in the same way as the existing channels.
If you set this to “Off”, only the factory-set frequency range will be searched.
When you have made your settings, use the

buttons to select “Start Search” and press
the

button to start searching. You can cancel the search at any time by pressing the button.
During the search you will see a display that shows you the progress of the search.