Kathrein UFD 520 - Manual (Page 21)

Programme selection
Reception status - radio
After the switch-over of the receiver, simply press the
ou
buttons to select
other radio programmes in their ascending or descending order in the programme
memory.
Every time you press the button, an on-
screen display shows you the selected
programme together with the time, the
programme start and end times as well as
the programme title in the information box
provided these data are transmitted
together with the signal.
By pressing the
O
button, you can exit this information box permanently displayed
or switch it off by pressing the button once again.
A further option of selecting a different
programme is to press the
i
button.
The radio programme list is now
displayed. In the left column, it will
provide information relating to the
received satellites, the transponder and
its transmission frequency, the
polarisation, the symbol rate and the
scrambling. The programme number, the
programme broadcaster and the type of
reception signal (free to-air/scrambled) is
shown on the right.
By pressing the
ou
buttons you jump to the next programme and by press-
ing the
-+
buttons you jump to the neighbouring page or enter-in the channel
number with the buttons on the remote control.
Confirm your programme selection by pressing the
O
button, or press the
L
button to exit the programme list and remain in the programme already set.
Selecting a radio programme by number entry
You can select a different radio programme during a current radio programme by
entering the programme location number. Use the number buttons
1
to
0
for
the purpose of entering the programme location number.
Example You wish to select the radio programme "DLR-Berlin". This programme is stored
under the programme location number 015. (The order of radio programmes is de-
fined in the programme memory and therefore only serves as an example here.)
To select this programme, press the numbers
1
and
5
one after the other. The
receiver waits for about 3 seconds for entry of the next number.
Follow the same procedure for all other programmes – i.e. also programmes with
three-digit programme location numbers. You do not have to enter leading zeros.
21