Power-ring-light status – Kodak DX7590 User Manual
Page 65
Troubleshooting
www.kodak.com/go/support
57
Power-ring-light status
Picture is not clear
■
To automatically set exposure and focus, press the Shutter
button halfway and hold. When the AF/AE indicator turns
green, press the Shutter button completely down to take
the picture.
■
Clean the lens (
).
■
Make sure camera is not in Close-up mode if you are more
than 21 in. (0.7 m) from your subject.
■
Place the camera on a flat, steady surface or use a tripod,
especially in high-zoom settings or in low light.
Status
Cause
Power ring does not
turn on and the
camera does not
work.
■
Turn on the camera.
■
Recharge the battery or install a new one (
).
■
Turn Mode dial off, then back on.
Power ring glows
steady green.
■
Camera is on and ready to take a picture or video.
Power ring glows
steady amber.
■
Camera is in Favorite mode.
■
Camera firmware update is in process.
■
Camera is connected to computer, USB connection
is active.
■
Date and time set with lens retracted.
Power ring
blinks green.
■
Camera turned off while picture is being processed and
saved. Camera operating normally. Processing is
completed before power off.
■
Do not remove the card while the light is blinking.
■
Camera operating normally at power up. Take pictures
when the blinking stops.
■
Camera operating normally during connect mode to
computer.
Power ring
blinks amber.
■
Battery is low or exhausted. Recharge the
battery (
).
■
Internal camera temperature is too high. Turn the camera
off for several minutes; then turn it back on. If the
condition continues, get help (
If...
Try one or more of the following