Kyocera Phantom TXLCC10042B - Manual (Page 19)

User Guide for Kyocera Phantom Phones 11
Setting roaming alerts and
ringers
Setting an alert for roaming
You can set your phone to alert you with beeps when
you roam outside of your home service area.
1. Select Menu
→
Settings
→
Network
→
Roam/Svc Alert .
2. Select an option and press .
– When no svc alerts you with three tones
decreasing in pitch when service is lost and
three tones increasing in pitch when service
is acquired again.
– Roam Change alerts you with two
decreasing tones when roaming service is
acquired and three increasing tones when
home area service is acquired again.
– Any Change alerts you with three
increasing tones if there is a change in
roaming service or three decreasing tones
if the phone loses service.
Setting the roam ringer
You can set a ringer to indicate when an incoming
call will be subject to roaming charges.
1. Select Menu
→
Settings
→
Sounds
→
Roam Ringer .
2. Highlight Enabled and press . You’ll hear a
sample of the ringer.
3. Press to set the ringer.
Setting Call Guard to avoid roaming calls
You can set your phone to warn you before you
answer or place a call while roaming.
• Select
Menu
→
Settings
→
Convenience
→
Call Guard
→
Call prompt .
The phone makes a distinctive ring to indicate an
incoming call while you are roaming, and you must
press
to accept the call or to place a call
while roaming.
Controlling network roaming
Specifying digital or analog mode
You may force the phone into either digital or
analog mode. This is useful if you are in an area
that borders on digital service and the automatic
feature is causing the phone to keep switching
between modes.
1. Select Menu
→
Settings
→
Network
→
Digital/Analog .
2. Select an option and press .
– Automatic automatically switches the phone
between digital and analog.
– Analog only sets the phone to work in
analog mode only.
– Analog call forces a call into analog mode
for the duration of the next call.
– Digital only sets the phone to work in digital
mode only.