Kenwood R-K711 - Manual (Page 42)

42 R-K711
Playback from External Components
You can play tracks by connecting external components to the system.
External Components
Connect the external component to the system as described in “Connecting
Other Accessories (Commercially Available Units)” (P.12).
When connecting external components, always turn this system and the external
components off beforehand.
Refer also to the instruction manual for the external component to be connected.
z
z
1 1
3 3 Adjust the volume level.
Press the [INPUT SELECTOR] key to select the input source to
be used for playback.
The input source changes as shown below each time you press the key.
2 2 Begin playback on the connected external component.
Begin playback using the controls on the connected external component.
When a digital component is
selected, the input signal sampling
frequency is displayed.
The R-K711 will play PCM (32 kHz
– 96 kHz) digital signals.
z
z
D-IN PHONO TAPE AUX