Kyocera E4000 - Manual (Page 13)

13 Startup
Installing the back cover
Place the back cover onto the back of
your phone and slide it forward until the
latch catches the cover.
Charging the battery
The battery is not fully charged when
first unpacked. Before using the battery
for the first time, charge it for at least
two hours (the battery is 90% charged in
two hours).
Use the provided charger cable for
charging. Connect one end of the
charger cable into the phone and the
other into a wall outlet to begin
charging.
You can also charge your phone using
the USB data cable while it is connected
to the PC as an alternative to the charger
cable.
Icons in charging
Different messages and icons may
display while charging.
The phone may show the following
icons when it is switched off:
• Do not remove the battery while
charging to avoid possible damage, e.g.
loss of data.
• It takes at least one charging-
discharging cycle for the battery to
reach its peak performance.
• When the battery is discharged, the
charging may not start immediately
when you plug in the connector. Wait 2
to 5 minutes for the phone to begin
charging.
• Charging is only possible within a
temperature range of 0 °C (+32 °F) to
+45 °C (+113 °F).
Charging is in progress.
Charging is complete.
Invalid battery. Please use a
genuine one.
Invalid charger. Please use a
genuine one.
Battery temperature is too high
and charging is terminated.
Timeout of charging. Charging
is terminated.