Kyocera E4000 - Manual (Page 15)

15 Startup
search for the designated network. This
search process may take a few seconds.
First time startup
After you have installed the battery and
finished charging it, you are ready to
power ON the phone. The first time you
power ON the phone, you will be guided
through a series of setup screens. Follow
the on-screen instructions or the steps
below to start up your phone and
complete the initial setup.
1. With the battery and the SIM card
inserted, press and hold to
power ON the phone.
2. Wait for the phone to boot up. This
may take a moment.
3. If your SIM card is protected by the
PIN, you will be required to enter the
PIN when the phone is powered on.
Press (
Done
) or to
proceed.
4. Set up the time information,
including the time zone of your
location, the date and the time. Press
(
Next
).
Or you can set the time information
later while synchronizing your phone
with a PC.
5. Press (
Next
) to enter a
password if you want to protect
access to your data and available
networks while using the phone. If
you do not need the password, press
(
Skip
).
6. Press (
Next
) to set up an E-mail
account if you want to send and
receive e-mail messages on this
phone. Or press
(
Skip
) to
complete the setup process.
Signal strength
The signal strength is indicated in the
top right corner of the display. The
number of bars displayed indicates the
strength of the signal (the more bars the
stronger the signal).
Strong signal.
• The SIM card can be protected with a 4-
to 8-digit PIN.
• The SIM card will be locked if you enter
the PIN incorrectly three times in a row.
You must then enter the PUK (Personal
Unblocking Key) for the SIM card in
order to unlock it. Please contact your
service provider to obtain a PUK.
• To activate/deactivate/change PIN, see
"Change SIM PIN" on page 24.
Please note that your phone needs about 5
seconds to finish the booting procedure.
If you want to switch the power off after
you power it on, wait for 5 seconds to
power off the phone.
The signal strength meter will show no
bars if the phone is not able to detect the
designated network or links to a network
that you are not authorized to use. You
will only be able to make emergency calls
in this case.