Kyocera KM-P4845w - Manual (Page 30)

CHAPTER 4 PRINTER OPERATION
4-2
2. Printing with manually fed media
When printing through the bypass slot, perform the following
procedure.
NOTE
• Only one sheet of paper can be set onto the bypass table at a time.
• When using curled paper, smooth the paper. If the curling persists,
place the paper with the curled surface up.
1 Adjust the bypass guides to the paper size indications on
both sides of the bypass table.
2 Set the paper face down all the way into the feed slot aligned
with the paper size indication.
When placing paper in the bypass table, set the paper
quickly all the way into the feed slot. Once the paper is fed,
release the paper. If the paper is not set properly, a paper
jam may be detected.
If the paper is set obliquely, pull the paper out and then insert
it again.
3 Perform the appropriate printing procedure on your
computer.
NOTE
Refer to the On-Line Manual for more detailed information on printing
from your computer.
4 When the message “Set paper. bypass” appears, refer to
Step 2 and set the next sheet onto the bypass table. Printing
will start. Repeat this procedure to set sheets one at a time
onto the bypass table until the required number of sheets
has been loaded and printed.