Kicker LIVIN LOUID SS65.2 - Manual (Page 19)

19
SS Component Systems
Installa
tion
When installing the speaker wire into your car be sure to avoid sharp edges and the
possibility of it getting pinched. Be careful to keep it out of the path of moving
mechanical parts such as the steering column, brake pedal, gas pedal, clutch pedal,
emergency brake, heater or AC control linkage and any other moving mechanical
systems. Be careful when re-installing any kick panel, sill plate or other interior body
panel removed to route the wire that you don’t damage the wire with attachment clips or
screws.
If running the wire into a door, an existing boot in the door jamb is the ideal place to
run the wires, but sometimes this does not
exist or is inaccessible. Drilling holes to run
wires through is very tricky, and caution must
be exercised not to drill into other wiring or
mechanisms. Any time a wire is run through a
bare hole, it is necessary to insert a rubber or
plastic grommet to
protect the wire.
To Crossover
Stagger Holes
For Wiring &
Use Grommets
(When Factory Are Not Avail.)