Kenwood KR-797 - Manual (Page 10)

KR-897/KR-797 (En)
10
÷ When changing the setting of the FM DE-EMPHASIS / CHANNEL
SPACE switch, first disconnect the power cord of the amplifier, then
reset the channel space switch, connect the power cord again, and turn
the power on.
CHANNEL
SPACE freq.
FM DE-
EMPHASIS
75 µs 1
U.S.A., Canada,
Hawaii, South
American countries
Other countries 50 µs 2
FM: 50kHz
AM: 9kHz
FM: 100kHz
AM: 10kHz
Area
FM DE-EMPHASIS / CHANNEL SPACE switch
(Except for U.S.A. and Canada)
The FM DE-EMPHASIS / CHANNEL SPACE switch on the rear panel is
set to the correct setting that prevails in the area to which the unit is
shipped. However, if the FM DE-EMPHASIS / CHANNEL SPACE setting
is not matched to the area where the unit is to be used; for instance,
when you moved from area 1 to area 2 or vice versa, desired reception
of AM / FM broadcasts is not expected. In this case, change the FM DE-
EMPHASIS / CHANNEL SPACE setting in accordance with the area
corresponding to the table. The FM DE-EMPHASIS is switched over at
the same time.
REC OUT
PLAY IN
VIDEO 1
/TAPE 1
PLAY IN
TAPE 2
MONITOR
VIDEO 2
SUB WOOFER PRE OUT
PLAY IN
+
−
FRONT SPEAKERS ( 8 −16Ω)
REAR SPEAKERS ( 4 −8Ω) CENTER SPEAKERS ( 8 −16Ω)
+
−
SYSTEM CONTROL
SWITCHED AC 110-120V AC 220-240V 50/60Hz
FM 75 Ω
GND
AM
ANTENNA
CD
PHONO
L
R
R L
R L
R L
C
AUDIO
FM 300 Ω REC OUT
DE − EMPHASIS
CHANNEL
SPACE 50 μs AM 9kHz
FM 50kHz
75 μs AM 10kHz
FM 100kHz
DE −
EMPHASIS
CHANNEL
SPACE
50 μs
AM 9kHz
FM 50kHz
75 μs
AM 10kHz
FM 100kHz
ƒ
ADAPTOR
L
R
L
R
OUT IN
AC 220-
240V AC 110-
120V
07.6.11, 5:06 PM 10