Kenwood KR-797 - Manual (Page 13)

KR-897/KR-797 (En)
13
1. The supplied batteries are intended for use in operation checks. Therefore, their lives may be shorter than ordinary batteries.
2. When the remote-controllable distance gets shorter than before, replace both batteries with new ones.
3. Malfunction may occur if direct sunlight or the light of a high-frequency lighting fluorescent lamp enters the remote control light
sensor. In such a case, change the system installation position to prevent the malfunction.
Operation procedure
Notes Notes
Select the component to be remote controlled
with one of the controlled component selection
keys.
Refer to the remote control key correspondence
table below and press the key for the desired
operation.
6
BAND
1 ¡
2
TUNER CD
7
AUTO
DISK SKIP
A/B +100
2Controlled component
selection key
3Operation key
4 ¢
P.CALL
A/B key
Press TAPE A or B +100
4 , ¢
(Skip key)
1 , ¡
(Tuning keys)
Press to tune broadcast
stations.
AUTO key
Press to select the auto
tuning mode.
P.CALL keys
Recalls preset stations.
4 , ¢
(Skip key)
BAND key
Press to switch the broad-
cast band.
7
(Stop key)
DISC SKIP key
Press to select the disc to
be played.
6
(Play/pause key)
1 , ¡
(Search key)
7
(Stop key)
6
(Forward play key)
1 , ¡
(Search key)
6
(Play key)
7
(Stop key)
1 , ¡
(Search key)
™
(Reverse play key)
* 1
1
Switch ON the power of the main unit.
Approximate operating range
÷ *1: No remote control key is marked MD, but the
TAPE1 key can be used to control a MD player by
switching the display of the main unit from TAPE1
to MD.
$
Remote
sensor
Model: RC-R0505
Infrared ray system
÷ Pressing the POWER key of the remote control unit while the STANDBY
indicator is lit turns the power ON. Press the desired key after the
power has been turned ON.
÷ When two operation keys of the remote control unit are pressed
successively, press each key securely reserving an interval of more
than 1 second for each press.
(When used with a MD)
Remote control key correspondence table (For KENWOOD component control mode)
TAPE1
TAPE1
SRS
3D POWER
PHONES
ON/STANDBY
INPUT SELECTOR VOLUME CONTROL
UP DOWN
STANDBY
1 2 3 4 5 6 7 8 9 0 +10
SPEAKERS
AUTO DIRECT MEMORY
AUDIO-VIDEO SURROUND RECEIVER KR-V797 PRO LOGIC STEREO SRS 3D
N.B. SOURCE DIRECT
P.CALL
3 STEREO
TUNING BAND DISPLAY TAPE2 MONITOR
SPEAKER
30°
6m
30°
POWER 1 2 3 4 5 6 7 8 9 DISK SKIP
0 +10
SOUND CENTER
MODE
A/B +100 VIDEO1
TAPE1 TUNER CD PHONO IDEO2 MUTE
1 ¡ 7 6
AV AUX
SETUP REMOTE CONTROL UNIT RC-R0505
4 ¢ 2 AUTO BAND P.CALL MONITOR TAPE2
VOLUME
CONTROL LEVEL
CONTROL LISTENI
MODE
2
3
07.6.11, 5:06 PM 13