Unpacking before applying power safety precautions, Before applying power – Kenwood KR-797 User Manual
Page 2
KR-897/KR-797 (En)
2
Units are designed for operation as follows.
Europe and U.K. .............................................. AC 230 V only
China and Russia ............................................ AC 220 V only
*Other countries ..................... AC 110-120/220-240 V switchable
U.S.A. and Canada ........................................... AC120 V only
Australia ....................................................... AC 240 V only
WARNING
: TO PREVENT FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS
APPLIANCE TO RAIN OR MOISTURE.
FM indoor antenna (1)
Remote control unit (1)
AC voltage selector switch
Unpack the unit carefully and make sure that all accessories are put aside so they will not be lost. Examine the unit for any possibility of shipping damage.
If your unit is damaged or fails to operate, notify your dealer immediately. If your unit was shipped to you directly, notify the shipping company without delay.
Only the consignee (the person or company receiving the unit) can file a claim against the carrier for shipping damage. We recommend that you retain the
original carton and packing materials for use should you transport or ship the unit in the future.
Unpacking
Before applying power
Safety precautions
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
Note:
Our warranty does not cover damage caused by excessive line voltage
due to improper setting of the AC voltage selector switch.
Before applying power
Accessories
THE LIGHTNING FLASH WITH ARROWHEAD SYMBOL, WITHIN AN EQUILATERAL TRIANGLE, IS IN-
TENDED TO ALERT THE USER TO THE PRESENCE OF UNINSULATED “DANGEROUS VOLTAGE” WITHIN
THE PRODUCT’S ENCLOSURE THAT MAY BE OF SUFFICIENT MAGNITUDE TO CONSTITUTE A RISK OF
ELECTRIC SHOCK TO PERSONS.
THE EXCLAMATION POINT WITHIN AN EQUILATERAL TRIANGLE IS INTENDED TO ALERT THE USER TO
THE PRESENCE OF IMPORTANT OPERATING AND MAINTENANCE (SERVICING) INSTRUCTIONS IN THE
LITERATURE ACCOMPANYING THE APPLIANCE.
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER
(OR BACK). NO USER-SERVICEABLE PARTS INSIDE, REFER SERVICING TO QUALI-
FIED SERVICE PERSONNEL.
*AC voltage selection
The AC voltage selector switch on the rear panel is set to the voltage
that prevails in the area to which the unit is shipped. Before connecting
the power cord to your AC outlet, make sure that the setting position
of this switch matches your line voltage. If not, it must be set to your
voltage in accordance with the following direction.
Move switch lever to match your line voltage
with a small screwdriver or other pointed tool.
REC OUT
PLAY IN
VIDEO 1
/TAPE 1
PLAY IN
TAPE 2
MONITOR
VIDEO 2
SUBWOOFER
PRE OUT
PLAY
IN
+
−
FRONT SPEAKERS
( 8
−16Ω)
SURROUND
SPEAKERS
( 4
−8Ω)
CENTER
SPEAKER
( 8
−16Ω)
+
−
SYSTEM
CONTROL
SWITCHED
AC 110-120V AC 220-240V
50/60Hz
FM
75
Ω
GND
AM
ANTENNA
CD
PHONO
L
R
R
L
R
L
R
L
C
AUDIO
FM
300
Ω
REC OUT
DE
−
EMPHASIS
CHANNEL
SPACE
50
μs
AM 9kHz
FM 50kHz
75
μs
AM 10kHz
FM 100kHz
ADAPTOR
L
R
L
R
OUT
IN
ƒ
AC 220-
240V
AC 110-
120V
AC 220-
240V
AC 110-
120V
3 Caution : Read this section carefully to ensure safe operation.
3 Caution : Read this section carefully to ensure safe operation.
Batteries (R6/AA) (2)
AM loop antenna (1)
Loop antenna stand (1)
Shorting pins (2)
(KR-797 only)
07.6.11, 5:05 PM
2