Kenwood TM-V7E - Manual (Page 44)

1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
38
STORING DATA IN PM CHANNELS
1 Confirm that the following conditions have been
satisfied:
• Both bands are in the receive mode.
• Scan is not being used on either band.
• Microphone Control is OFF.
2 Select the desired band.
3 Select the desired frequency and related data
(Tone, CTCSS, DTSS, etc.) using VFO mode.
4 If required, select another band, then select the desired
frequency and related data.
5 Press [F], [PM].
• The PM channel numbers appear and blink.
6 Press [1] to [4] corresponding to the desired PM
channel.
• The selected frequency and related data are stored in the
PM channel.
RECALLING PM CHANNELS
1 Press [PM].
• The PM channel numbers appear.
2 Press [1] to [4] corresponding to the desired PM
channel.
• The contents of the selected channel are recalled.
• The selected channel number appears at the left bottom
of the display.
• To exit PM Recall mode, press [PM], [VFO].
Note: You cannot recall a PM memory channel while transmitting.
VOL SQL
CALL
1
2
VOL SQL
CALL