Kenwood TM-V7E - Manual (Page 61)

1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
55
CALLING
Note: Before making a call, store your Station code in channel A, and
store the desired Station codes or Group codes in channels 1 to 5.
1 Select the desired band.
2 Tune to the prearranged frequency.
3 Press [F], [DTSS] twice to switch Page ON.
• "PAG" appears.
• If DTSS is already ON, press this key combination once.
4 Press [F] (1 s), [C.SEL].
5 Turn the Tuning control, or press Mic [UP]/[DWN], to
select the channel that contains the desired Station
code or Group code.
6 Press [OFF] or Mic [PTT] to restore the frequency
display.
7 Press and hold Mic [PTT].
• The selected Station code or Group code is transmitted
along with your Station code.
8 To switch Page OFF, press [F], [DTSS].
Note:
◆ Each time you press [PTT], the microphone is inhibited and the Page
code is transmitted. After establishing a contact, you can eliminate
this pause by switching Page OFF.
◆ When recalling either a memory channel or the Call channel with
DTSS status ON while using the VFO with Page switched ON, page
is given priority.
RECEIVING
1 Select the desired band, and tune to the prearranged
frequency.
2 Switch Page ON.
3 You are ready to receive a call.
• When your transceiver receives a signal encoded with
your Station code or a Group code, the squelch opens, an
alert sounds, and "PAG" blinks.
• If you are called with your Station code, the display shows
the calling station’s code.
• If called with the Group code, the display shows the group
code.
4 To respond to the calling station, press Mic [PTT] while
the Page code is visible on the display.