Kenwood TM-V7E - Manual (Page 52)

1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
46
PROGRAM SCAN
Program Scan is similar to VFO Scan except that you
select the frequency range of the scan.
■ Setting Scan Limits
You can store up to three scan ranges on each band,
using memory channels L1/U1, L2/U2, and L3/U3.
1 Select the desired band.
2 Turn the Tuning control, or press Mic [UP]/[DWN],
to display the desired lower limit.
3 Press [F].
4 Turn the Tuning control, or press Mic [UP]/[DWN],
to select channel L1, L2, or L3.
5 Press [MR].
• The lower limit is stored in the channel.
6 Turn the Tuning control, or press Mic [UP]/[DWN],
to display the desired upper limit.
7 Press [F].
8 Turn the Tuning control, or press Mic [UP]/[DWN],
to select channel U1, U2, or U3.
• If you have selected for example L1 in step 4,
select U1.
9 Press [MR].
• The upper limit is stored in the channel.
10 To confirm the stored scan limits, press [MR], then
select the L and U channels.
Note:
◆ The lower limit must be lower in frequency than the upper limit.
◆ The lower and upper frequency steps must be equal.
◆ The lower and upper limits must be selected on the same band.