Kenwood KCA-BT100 - Manual (Page 11)

English | 11
In Standby mode
Setting the Time Interval for
Automatic Answer
This function automatically answers (responds
to) a call after lapse of the preset time interval for
automatic answer.
Display Setting
"Auto Answer: OFF"/
"ANS OFF" Does not answer the phone call automatically.
"Auto Answer: 0s"/
"ANS 0" Automatically answers the phone call at once.
…
"Auto Answer: 8s"/
"ANS 8" Automatically answers the phone call after lapse
of 8 seconds (original setting).
…
"Auto Answer: 99s"/
"ANS 99" Automatically answers the phone call after lapse
of 99 seconds.
• If the time set in the cell-phone is shorter than that set in
the unit, the former will be used.
In Standby mode
Setting up the Voice Output Speakers
You can specify the voice output speakers.
Display Setting
"SP Select: Front"/
"SPK FRT" Outputs voice from the front-left and front-right
speakers.
"SP Select: F-R"/
"SPK F-R" Outputs voice from the front-right speaker.
"SP Select: F-L"/
"SPK F-L" Outputs voice from the front-left speaker.
• Select the speaker which is further from the microphone
in order to prevent howling or echos.
In Standby mode
Setting the Beep of the Incoming Call
You can output a beep from the speaker when a call
comes in.
Display Setting
"Call Beep: ON"/ "C-BP ON" Beep is heard.
"Call Beep: OFF"/ "C-BP OFF" Beep is canceled.
If your control unit supports a graphic display
function:
1 Select the status display item
Push the Control knob towards [FM] or [AM].
Select the "Phone Status" display.
2 Display the statuses
Push the Control knob towards [ 4] or [¢].
All statuses are indicated with icons.
3 Exit Menu mode
Press the [MENU] button.
Bluetooth connection status
Display Icon Information
"BT-CON Y" Connected
"BT-CON N" Disconnected
Battery level of cell-phone
Display Icon Information
"BAT FULL" Full
"BAT MID"
…
…
"BAT LOW" Nearly dead
"BAT - - -" Cannot get information.
Signal strength of cell-phone
Display Icon Information
"SGNL MAX" Maximum
"SGNL MID"
…
…
"SGNL LOW" Minimum
"NO SGNAL" Outside the service range
"SGNL - - -" Cannot get information.
• Since the number of steps of the control unit is different
from that of the cell-phone, the statuses displayed on
the control unit may discord from those displayed on
the cell-phone.