Kenwood KCA-BT100 - Manual (Page 20)

20 | English
Installation
Installation the Hands-Free Box
• Determine the installation position after making sure that
the unit can communicate with the cell-phone.
• Please do not install the unit near the dashboard, the rear
tray, or other important components. Doing so could lead
to injury or accident should the unit come off due to a
shock and strike a person or an important component.
Tapping screws should be used for mounting. (Attachment
with velcro strips, although easy, can come off with a
shock.)
Securing to audio board
Installation the Microphone Unit
1 Check the installation position of the microphone
(accessory 1).
2 Remove oil and other dirt from the installation
surface.
3 Install the microphone.
4 Wire the microphone cable up to the hands-free
box with it secured at several positions using tape
or the like.
Fix a cable with a commercial
item of tape.
Peel the release coated paper of double-face adhesive tape
to fix on the place shown in the left-hand example.
Adjust the direction of the microphone to the driver.
Securing to pile carpet
Accessory 3
Antenna part
• Do not stick the velcro tape over the serial number.
• If the installation place is stepped, cut the velcro tape into
two pieces and stick them at two positions as shown.
Antenna part
Accessory 2 (Ш4 Ч 16 mm)