Kathrein UFD 574/S - Manual (Page 24)

Sound Settings
24
Sound Settings
Adjusting the Volume
Press

on the remote control of the receiver to adjust the desired
volume. A bar indicating the volume is displayed on the screen.
Stereo and Dual-Channel Sound Reproduction
The sound reproduction setting is shown in the channel information,
which can be called up by pressing

(depending on where the
'sound wave' icon appears –underneath the displayed time- mono left,
mono right or stereo can be set, the figure indicates which is set). The
programme title is displayed in the small box on the right.
Press the yellow

key to call up the audio menu for the sound and
language selection. You can make the desired settings if the
corresponding data are provided in the reception signal, as are e.g.
language selection (sound track), Dolby Digital (5.1 CH). Select the
menu items by pressing

, and make the desired settings with

. Press

again to exit the menu.
If subtitles are broadcast, you can select the language with

in
the bar 'subtitle track'. Confirm your entry by pressing

.
AC 3
The receiver has an audio output for the AC 3 format. This means
you can enjoy cinema-like sound quality in your living room with the
appropriate equipment. Connect the digital audio output only to a
suitable HiFi unit.
Please observe the owner manual of your Dolby Digital unit.
In order to have the AC 3 format reproduced, make the following
settings: Call up the audio menu, scroll to position 'stereo', set the
receiver to '1 of 2' or '2 of 2' respectively (2 CH). Now, 'Dolby
Digital/AC 3' is displayed in position 'digital output' – if broadcast
correspondingly.
Only a few programme providers broadcast the AC 3 format. If no AC
3 signal can be received, you can merely make the standard
mono/stereo settings or select a language which is broadcast.