Kenwood CarPortal KOS-V1000 - Manual (Page 72)

72 KOS-V1000
Setting EXT SW Control 2 (EXT SW2)
1
2
3
4
The setup method is the same as "EXT SW1".
Setting EXT SW Control 3 (EXT SW3)
1
2
3
4
The setup method is the same as "EXT SW1".
Setting EXT SW Control 4 (EXT SW4)
1
2
3
4
The setup method is the same as "EXT SW1".
Setup Menu
EXT SW Setup
Setting up power specification of the external
device for which the power is controlled from
this unit.
1 Display the EXT SW SETUP screen
Touch [Ext SW SETUP] in the SETUP Menu
(page 56).
2 Perform EXT SW Setup
Setting EXT SW Control 1 (EXT SW1)
1
2
3
4
1 Sets the name of the external device. See
<Character Entry> (page 47) for information
on how to enter the name.
2 Sets the power signal output mode.
( EXT SW1: Pulse, EXT SW2: Level,
EXT SW3: Pulse, EXT SW4: Pulse)
Pulse: Generates a single power signal
pulse.
Level: Continues output of high power
signal.
Sets to turn output on/off each time the
button on the EXT SW Control screen is
pressed.
3 Sets the Pulse signal output time.
Outputs 500ms when "1" is set. Increases
by 200ms with each step. Up to 100 steps
can be set.
4 Returns to the original screen.