Kodak RP 30 - Manual (Page 195)

Maintenance
Maintenance Schedule and Maintenance Intervals
Daily Weekly Monthly When
required
Maintenance jobs to be performed by the customer
Perform process control on the paper processor
Transport unit: Remove paper dust
Single sheet buffer and sheet bridge: Remove paper dust
Print engine: Remove paper dust
Lane distributor: Remove paper dust / deposits
Sheet transfer to paper processor: Remove paper dust
Clean tank crossovers of the paper processor
Clean CD feed unit
Clean squeegee and wiper unit (V wipers)
Check solution levels, top up if necessary
Clean chemical filters
Clean filter in ASTOR and water inlets
Clean densitometer calibration plate
Print chute: Clean transport belt
Check solution temperatures
Clean air filters
– Below cutter units
– Door to print engine
– Paper processor: right-hand side wall, dryer and AC
supply
Replace the chemical filters
Clean processing racks
Clean dryer rack
Clean paper outlet:
– Clean / replace air filter
– Clean slide plate with feed chute
– Clean rubber transport belts
Change back printer ink ribbon
Empty effluent tanks
WARNING: Be sure to observe the safety precautions on all equipment
labels and in the Regulatory and Safety section of this manual.
Do not clean while the drive is switched on.
To avoid risk of injury, be careful when working around the
toothed belts, sharp corners, and edges in the printer area.
KODAK PROFESSIONAL RP 30 Laser Printer 8-3