Operation, Initial start-up, Setting up the device – Kathrein MSK 200/S2 User Manual
Page 7: Set-up options
7
OPERATION
INITIAL START-UP
Prior to operating for the fi rst time, please take the T 8.0 A fuse out of the packaging and fi t it into the provided
fuse holder.
The fuse prevents the device being switched on unintentionally during transport.
Caution!
Please remove this fuse again before shipping the device!
Remove the AC power supply unit (100V ... 250V) supplied from the packaging and connect the device to
the mains using the power supply. The Li ion rechargeable battery in the device will now be charged. The
green light emitting diode indicates use of an external power source. You can check the charge state of the
rechargeable battery by pressing the “Test“ key.
SETTING UP THE DEVICE
When setting up the device pay attention to adequate ventilation!
To avoid a build-up of heat, the openings for the fan and the ventilation holes must always be kept clear.
Set up the device as shown in the fi gure.
Caution!
See also “Charging indicator” and “DC supply socket” in the section “Interfaces”
SET-UP OPTIONS
After insertion of the protector, the device muss be operated or charged on the power supply unit for ap-
proximately two hours. Subsequently, the device must be completely discharged during battery-powered
operation (until the device switches off by itself). Battery charge level can only be correctly displayed if the
device has been fully charged and then fully discharged.