Loading film - cont’d full-auto operation – Konica Minolta Vectis 300 User Manual
Page 12
20
21
LOADING FILM - CONT’D
FULL-AUTO OPERATION
1. Press the main switch to turn the
camera on.
• The camera is set for fully-automatic operation
and the flash will fire automatically when
necessary.
2. Select the print format. The viewfinder
will change to match your selection.
Hold the camera steady, making sure your
fingers do not cover the flash. If you are taking
a vertically framed picture, turn the camera so
the flash is on top.
If 0 and the film transport signals blink in the data
panel, turn the film chamber release, open the
chamber, then remove the film.
- If the film’s current VEI is
, insert a new roll of film.
- If a partially exposed roll of film was loaded into this
camera, the VEI has been changed from
to
.
- If a processed roll of film was loaded into this camera,
the VEI has been changed from
to
.
- If the film’s current VEI is
, remove the film, remove
and reinsert the battery, then reload the film. If the film
will not load, contact the nearest authorized Minolta
Service Facility.
Continued on following page.