Kicker SX900.4 - Manual (Page 3)

3
SX .4 Series Amplifiers
F
e
a
tures
Features
Low Impedance Operation Stable into 2 ohm stereo or 4
ohm mono loads.
SORT Protection Circuitry (Short circuit, Over-voltage,
Reverse polarity, Thermal) Protects amplifier from accidents and
out of spec operation.
MOSFET Power Supply Provides high efficiency operation.
PAST (Pre Amp Signal Transfer) Output RCA jacks to pass the
incoming signal to another amplifier or component.
SAMS (Stereo And Mono Simultaneously) Amplifier will operate
into a bridged mono load and a stereo load at the same time.
Low Pass Filter Fully adjustable digital crossover with variable
slope and crossover frequency. 30Hz - 20kHz in 1/12 octave
spacing. OFF - 36dB per octave slope in 6dB increments.
High Pass Filter Fully adjustable digital crossover with variable
slope and crossover frequency. 10Hz - 16kHz in 1/12 octave
spacing. OFF - 36dB per octave slope in 6dB increments.
KickEQ Fully adjustable single band digital parametric equalizer
with variable Q (bandwidth), variable center frequency and
variable boost or cut. Q range .5 - 10 in .5 steps. Center
frequency 20Hz - 20kHz in 1/12 octave steps. Boost or cut range
+/-18dB.
Adjustable Phase The output phase of each channel can be
set at 0 Degrees or 180 Degrees. Left and Right channels can
be linked or independently adjusted.
UltraMatch Gain Structure Digital input gain control with five
selectable gain ranges (1 volt, 2 volt, 4 volt, 8 volt, 16 volt) with
12dB of adjustment in each range in .5dB steps. Left and Right
channels can be linked or adjusted independently.
SickBay and On Board Diagnostics Various tools to
troubleshoot installation issues and check amp status.
Kompressor A 4-setting, user-selectable bass compressor
used to fatten up your sub bass. OFF, RED-LINE, CONTOUR
and ATTACK with +/-24dB of adjustment to compensate for
speaker size, speaker location, vehicle size or listening style.
ISIS (pronounced “eye-sis”) ( I ndicate S tatus & I nput S ettings)
The user interface to view or adjust current settings and check
the status of your Kicker SX amplifier.
BLAST Port ( Bass Level And Signal Transfer) Provides
Remote Bass Level Control and control signal transfer between
multiple SX amplifiers.
EndKaps Cast aluminum, custom, removable covers to protect
and hide all your wiring connections to the amplifier. Can be
prepped and painted any custom color you choose.
SASA (S hake A S tick A t ) So many more features...it is more
than you can Shake A Stick At. (It’s an Oklahoma thing!) Read on
to find out!