Lenovo 4304493 - Manual (Page 9)

Attention
Be sure to insert and remove the interface cable and PC
Card carefully. The connectors on the interface cable are
designed to be inserted in only one position; they cannot be
inserted upside down. If you try to insert the connectors
upside down, you might damage them. Make sure that the
pins on the cable connectors are aligned with the holes in
the interface connectors. If they are not aligned and you
force the connection, you might damage the connectors.
Also, if you use excessive force when inserting the PC
Card, you might damage the card or your computer.
2 Make sure that your computer and the CD-ROM drive are
turned off. Squeeze both sides of the large connector on the
interface cable, and connect it to the end of the PC Card.
Squeeze both sides of the small connector on the interface
cable, and connect it to the CD-ROM drive interface
connector
3 (Bottom view). Plug the PC Card into an
available PC Card slot on your computer.
3 Turn on the computer and turn on the CD-ROM drive by
moving the power switch 7 (Bottom view) to the ON position.
4
Install the device drivers.
a. If you are using DOS or Windows 3.11:
1) For DOS: Insert the Option Diskette into drive A. At
the DOS prompt type a:\install, then follow the
instructions on the screen. When installation
completes, restart DOS.
2) For Windows 3.11: Insert the Option Diskette into
drive A. Using File Manager, go to the File menu,
select Run, then type a:\install on the command line.
You will be prompted to choose one of two
installation options.
Automatic installation
The setup program will automatically install
the required software into your computer.
Selective installation
The setup program installs the required
software into your computer after you
specify the following items:
Software installation destination
Installation destination directory name
IRQ number
I/O base address
3) If you have Windows 3.11 and are installing the audio
device driver:
a) Insert the Option Diskette into drive A. Use File
Manager to locate setup.exe, then double-click on
it.
b) Run Install Driver and Install Application
according to the instructions on the screen. Then
restart your computer.
Part 1: Quick Installation Guide 1-3