What the lights mean, Troubleshooting & faq – Lennox Hearth BT2010 User Manual

Page 10

Advertising

* Functions marked with * are dependent on your phone supporting these

features. Check your phone’s user manual for further information.

10. What the lights mean

What you see

What this means about your headset

Solid light:

In pairing mode – see Pairing section

Slow single flash:

Connected to phone and in standby mode*

Slow double flash:

Not connected to phone and in standby mode

Quick single flash:

Active on call

Quick double flash:

Incoming/Outgoing call

Triple flash:

Battery low

* BT2010 is equipped with Jabra Discreet Light feature, meaning that

light indicator (LED) turns off after 1 min of non-activity. Headset is still

active, and light will flash again after a tap on the answer/end button

or any call activity.

11. Troubleshooting & FAQ

I hear crackling noises

• For the best audio quality, always wear your headset on the same side

of the body as your mobile phone.

I cannot hear anything in my headset

• Increase the volume on the headset.
• Ensure that the headset is paired with the phone.
• Make sure that the phone is connected to the headset – if it does not

connect either from the phone’s Bluetooth menu or by tapping the

answer/end button, follow the pairing procedure (refer to pairing

section in this user manual).

• You can determine whether your headset is connected to a device by

looking at the flashes on the headset after tapping the answer/end

button when the headset is on: single slow flashes means that the

headset is connected to a device, double slow flashes means that the

headset is currently not connected.

I have connection problems

• You may have deleted your headset pairing connection in your mobile

phone. Follow the pairing instructions; refer to this section in this user

manual.