Lennox Hearth BT2010 - Manual (Page 6)


5. Charge your headset
Make sure that your headset is fully charged for 2 hours before you start
using it. Use the AC power supply to charge from a power socket. When the
light indicator (LED) has a solid LED light, your headset is charging. When
the solid LED light turns off, it is fully charged. (See fig 2)
Use only the charger provided in the box - do not user chargers from any
other devices as this may damage your headset.
Please note: The lifetime of the battery will be significantly reduced
if your device is left uncharged for a long period. We therefore
recommend that you recharge your device at least once a month.
6. Turning your headset on and off
• Press the answer/end button until you see a burst of flashes on the
indicator light (LED) to turn on your headset.
• Press and hold the answer/end button until you see a burst of flashes
on the indicator light (LED) to turn the headset off.
Please note that the LED indicator light turns off after 1 minute to save
battery. Headset is still active, and light will flash again after tap on the
Answer/End button or any call activity. To check if the headset is on,
tap the answer/end button once – the LED indicator light will flash, if the
headset is on.
fig 2