LA Audio EQX20 User Manual
Page 5
Page 5
2.0 INSTALLATION
IMPORTANT: PLEASE READ THIS SECTION BEFORE USING THE EQX20
2.1 INSPECTION AND UNPACKING
The EQX20 has been carefully packed at our factory in a carton designed
to withstand handling in transit. Should the unit appear to have been
damaged in transit notify your dealer immediately and do not discard any of
the packing. The carton should contain -
• The EQX20 unit
• Power cord
• Operator Manual (this book)
2.2 OPERATING ENVIRONMENT
The EQX20 is designed to operate between 0 and 50°C (32-122°F) with
relative humidity no more than 80%. Should the unit be installed in an
equipment rack, ensure that the environment conforms to these levels.
2.3 CE STANDARDS AND THE LOW VOLTAGE DIRECTIVE (LVD)
The EQX20 has been designed to meet the latest Electromagnetic
Compatibility (EMC) regulations. However we recommend you do not
operate the unit close to strong emitters of electromagnetic radiation such
as power transformers, motors, mobile telephones or radio transmitters.
The unit should only be connected to a power supply of the type described
in 2.4 POWER REQUIREMENTS or as marked on the unit. The unit must
be earthed for safe operation. Disconnect the mains supply before
removing any cover.
2.4 POWER REQUIREMENTS
There is a mains fuse located inside the unit which is accessed by
removing the cover. This fuse is for protection against unit faults and as
such will not normally need replacing. If you think you have a power related
problem please refer to your dealer.
The voltage and fuse rating have been factory set for -
230V
50mA
UK
220V
50mA
Republic of Korea
115V
100mA North America
• The correct voltage and fuse rating is indicated on the rear panel.