LA Audio EQX20 - Manual (Page 6)

Page 6
• Please check that your unit is correctly rated for the voltage of
the country of operation.
If the fuse requires changing at any time please ensure the correct fuse is
fitted. An incorrect fuse could cause damage to the unit and may constitute
a fire hazard.
If you carry your EQX20 from one country to another it is very important to
ensure the voltage is compatible.
For your information the unit can be internally rewired for use in 230V, or
110-125V countries - contact your dealer for information. A special 100V
version is available for Japan and a 220V, 60Hz version for Republic of
Korea.
The mains lead connections to the appliance are coloured in accordance
with the following code:
Green-and-Yellow Earth
Blue Neutral
Brown Live
• WARNING:
THIS APPLIANCE MUST BE EARTHED
2.5 SIGNAL LEVELS
The EQX20 will accommodate both -10dB and +4dB operating levels
without the need for level switching.
PLEASE NOTE: the XLRs are set for +4dBu and the TRS jacks for -10dBV
operating levels. Use the appropriate connector/level to interface between
your equipment and the EQX20.
Using the TRS jack input with +4dB signal levels in some set-ups will over
drive the EQX20 and cause distortion.
Signals in excess of +20dB will cause the unit to distort.
2.6 EXTERNAL CONNECTIONS
Fig 2.6.1 EQX20
rear view showing Input and Output connections