Lathem 4000 - Manual (Page 5)

2000 – 4000 Series Time Recorder User’s Guide
Page 3
Raise the Type Section
1. Unlock the case cover and pull it forward to remove it.
2. Note the position of the Release Latch and Face Setting Wheel
used later in this process.
3. Wait until you hear the clock “click”.
4. Press either side of the Type Section Headlock – Figure 1, 1.2
and pull upward on the lower part of the Clock Face until the
Type Section locks in the up position as shown in Figure 1.
Note position of the Overthrow Lever and the Setting Wheel.
5. Press the red Overthrow Lever – Figure 1, 1.3 away from you
until it clicks. This releases the wheels allowing them to turn.
Set the Time on the Type Wheels
Figure 2
1. Locate the Center Line where all the wheels line up as shown in
Figure 2.
2. Rotate the wheels using a pointed object. Rotate each wheel
until the correct date and time are aligned at the Center
Position, as shown in Figure 2. Hint: Start at the top wheel
and work down when setting.