Linksys SRW2008 - Manual (Page 21)

11 Chapter 3: Connecting the Switch
Placement Options
WebView Switches
Wall-Mount Placement
When mounting the Switch on the wall, the Switch should be mounted horizontally. The front panel should face
either up or down (see Figure 3-4). The unit should not be positioned vertically when mounted (see Figure 3-5).
You will need two suitable screws to mount the Switch.
1. Determine where you want to mount the Switch. Ensure that the wall you use is smooth, flat, dry and sturdy
and make sure the location is within reach of the power outlet.
2. Drill two holes into the wall. Make sure the holes are 3.7 inches (94 mm) apart. You can print the template
from this page.
3. Insert a screw into each hole, and leave 3 mm of its head exposed.
4. Maneuver the Switch so the wall-mount slots line up with the two screws.
5. Place the wall-mount slots over the screws and slide the Switch down until the screws fit snugly into the
wall-mount slots.
Congratulations! The Wall-Mount installation of the Switch is complete.
Print this page at 100% size, cut along the dotted
line and place on the wall to drill precise spacing.
Figure 3-4: Proper Wall-Mount Orientation (Horizontal)
Figure 3-6: Wall-Mount Template
IMPORTANT: When wall-mounting the switch, be
sure to mount it horizontally. Do not mount the
switch vertically.
Figure 3-5: Incorrect Wall-Mount Orientation (Vertical)