Linksys EG24M - Manual (Page 31)

10/100 Managed 24-Port GigaSwitch
PING SETTINGS
If you select Ping from the IP Networking screen, a Ping screen similar to the
following will appear, with the Host field highlighted.
Use the following procedure to change the ping settings:
1. Press Enter. The Enter IP Address screen will appear.
2. Type the IP address of the server you want to ping. The address consists of
numbers separated by periods (e.g., 129.32.0.11).
3. Press Enter.
4. Use the Down Arrow key to move to Count and press Enter. The Enter
Packet Count screen will appear.
55
Linksys EtherFast ® II Series
8. Press the Down Arrow key and press Enter to specify the preferred server.
When the following screen appears, type the delay, in seconds, and press
Enter.
9. To specify up to three more preferred servers, do so in the remaining
Preferred Field options.
10. When you finish, press Esc. The DHCP Gateway Settings screen will
appear, along with the parameters you specified.
11. To define additional DHCP gateways, repeat steps 1 through 10.
12. When you finish defining DHCP gateways, press Esc until you return to
the desired screen.
54