Linksys EG24M - Manual (Page 34)

10/100 Managed 24-Port GigaSwitch
2. Select either Disabled or Enabled and press Enter. Your selection will
appears next to Spanning Tree Protocol.
3. Use the Down Arrow key to move to Bridge Priority and press Enter. The
Enter Bridge Priority screen will appear.
4. Type a decimal number for the bridge priority and press Enter. The
decimal value you typed will appear next to Bridge Priority.
5. Use the Down Arrow key to move to Hello Time <sec> and press Enter.
The Enter Hello Time screen will appear.
6. Type a decimal number for the hello time and press Enter. The decimal
value you typed will appear next to Hello Time.
7. Press the Esc key to return to the Spanning Tree Protocol screen.
61
Linksys EtherFast ® II Series
SPANNING TREE FUNCTIONS
If you select Spanning Tree from the Advanced Management screen, the
Spanning Tree Protocol screen will appear.
Spanning Tree Protocol Configurations
Highlight Spanning Tree Configurations in the Spanning Tree Protocol screen
and press the Enter key. A Spanning Tree Protocol Configuration screen sim-
ilar to the following will appear. The top half of this screen displays read-only
values. The bottom half, starting with Spanning Tree Protocol, is user config-
urable. Use the Up Arrow and Down Arrow keys to highlight a field, then
press Enter to change the value. When you finish, press the Esc key until
you return to the desired screen.
Use the following procedure to modify the selections shown:
1. With the Spanning Tree Protocol field highlighted, press Enter. The fol-
lowing choices will appear (see next page).
60