LevelOne WCS-2060 - Manual (Page 43)

43
Application settings
Snapshot
“Enable snapshot” Enable/Disable snapshot application.
Weekly schedule
“Sun” ~ “Sat” Select the days of the week to perform the application.
Select “Always” or input the time interval.
Snapshot file name prefix
The prefix name will be added on the file name of the snapshot images.
Send out the snapshot while motion detection
There are three windows for motion detection each can be assigned a name. Select the windows
which need to be monitored. If motion detection has not been set up, “undefined” will be shown
instead of the window title. If this happens, clicking on “Motion detection” and a note will show to
direct the User to the configuration page for motion detection.
“Send pre-event image(s)”
The number of pre-snapshots will be captured and send when a
condition is triggered.
“Send post-event image(s)” The number of post-snapshots will be captured and send when a
condition is triggered.
“Delay second(s) before detecting next motion” Set the time delay before restarting to check
on the triggering condition when the current condition is triggered.
Sequential operation
“Snapshot interval : second(s)” Network Camera will send snapshots at the specified intervals
to the external server using the method selected below. Remember: This operation is still subject
to the conditions set in the weekly schedule.